Disabling And Enabling Lldp On A Supported Interface - Cisco ASR 920 Series Configuration Manual Ethernet Router

Disabling and Enabling LLDP on a Supported Interface

DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3
no lldp run
Example:
Device(config)# no lldp run
Step 4 end
Example:
Device(config)# end
Disabling and Enabling LLDP on a Supported Interface
LLDP is enabled by default on all supported interfaces. This section describes the tasks for disabling and
enabling LLDP on a supported interface.
Disabling LLDP on a Supported Interface
Perform this task to disable LLDP on a supported interface.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. no lldp {med-tlv-select tlv | receive | transmit}
5. end
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
334
Using Link Layer Discovery Protocol in Multivendor Networks
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Disables LLDP globally.
Returns to privileged EXEC mode.