Carrier Ethernet Configuration Guide (Cisco Asr 920 Series - Cisco ASR 920 Series Configuration Manual Ethernet Router

Example: Verifying the Ethernet Microwave Event Configuration
VSM Drop Count: 0
VSM Period: 10 seconds
Hold Timer: Not running
Wait-to-Restore Timer: 1 seconds remaining
Periodic Timer: Not running
Transitions into degraded state: 1
The following is sample output from the show ethernet event microwave status command where
Port-channel20 has been specified. Use the command to confirm that the configuration is performing as
intended.
Device# show ethernet event microwave status interface Port-channel20/2
Microwave Bandwidth Status for Port-channel20
State: SIGNAL_DEGRADED
Hold Time: 0 seconds
Restore Time: 10 seconds
Loss Threshold: 3
Total VSM Receive Count: 2
Total VSM Drop Count: 0
Sender Address 64f6.9d67.a053
State: SIGNAL_DEGRADED
Elapsed time in this state: 00:00:26
Nominal Bandwidth: 700 Mbps
Current Bandwidth: 100 Mbps
Lowest Bandwidth: 100 Mbps
Last VSM Received: Fri Apr 24 13:09:13.245
VSM Receive Count: 2
VSM Drop Count: 0
VSM Period: 10 seconds
Hold Timer: Not running
Wait-to-Restore Timer: Not running
Periodic Timer: 29 seconds remaining
Transitions into degraded state: 1
The following is sample output from the show ethernet event microwave status command displaying the
for Link ID TLVs:
Device# show ethernet event microwave status GigabitEthernet 0/0/2
Microwave Bandwidth Status for Ethernet0/0
State:
Hold Time:
Restore Time:
Loss threshold:
Total VSM Receive Count: 6
Total VSM Drop Count:
Link ID 4 (Sender Address aaa.bbbb.cccc)
State:
Elapsed time in this state:
Nominal Bandwidth:
Current Bandwidth:
Lowest Bandwidth:
Last VSM Received:
VSM Receive Count:
VSM Drop Count:
Hold Timer:
Wait-to-Restore Timer:
Periodic Timer:
Transitions into degraded state: 2
The following is sample output from the show ethernet event microwave statistics command where
GigabitEthernet interface 0/0/2 has been specified:
Device#show ethernet event microwave statistics GigabitEthernet 0/0/2
Microwave Bandwidth Status for GigabitEthernet0/0/2
State: SIGNAL_OK

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)

242
G.8032 and CFM Support for Microwave Adaptive Bandwidth
SIGNAL_DEGRADED
0 seconds
10 seconds
3
0
SIGNAL_OK
01:12:10
10000 Mbps
10000 Mbps
N/A, not in degraded state
Fri Jan 24 10:24:43.349
3
0
Not running
Not running
Not running