Carrier Ethernet Configuration Guide (Cisco Asr 920 Series - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet LMI Interaction with CFM
Command or Action
Example:
Device(config-if-srv)# ethernet lmi ce-vlan
map 30
Step 17
ethernet lmi interface
Example:
Device(config-if-srv)# ethernet lmi
interface
Step 18 encapsulation dot1q vlan-id
Example:
Device(config-if-srv)# encapsulation dot1q
2
Step 19
bridge-domain domain-number
Example:
Device(config-if-srv)# bridge-domain 1
Step 20 cfm mep domain domain-name mpid mpid-id
Example:
Device(config-if-srv)# cfm mep domain
provider mpid 10
Step 21
exit
Example:
Device(config-if-srv)# exit
Step 22 service instance service-instance-id ethernet
Example:
Device(config-if)# service instance 22
ethernet
Step 23 encapsulation untagged
Example:
Device(config-if-srv)# encapsulation
untagged

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)

292
Configuring Ethernet Local Management Interface at a Provider Edge
Purpose
To specify both VLAN IDs and untagged VLANs in
Note
the map, specify the VLAN IDs first and then specify
the untagged keyword as follows: ethernet lmi
ce-vlan map 100,200,300,untagged. Also, if the
untagged keyword is not specified in the map
configuration, the main interface line protocol on the
Customer Edge (CE) device will be down.
Enables Ethernet local management interface (LMI) on a UNI.
Defines the matching criteria to map 802.1Q frames ingress on
an interface to the appropriate service instance.
Binds a service instance to a bridge domain instance.
Configures a maintenance endpoint (MEP) for a domain.
Returns to interface configuration mode.
Configures an Ethernet service instance on an interface and
enters Ethernet service configuration mode.
Defines the matching criteria to map untagged ingress Ethernet
frames on an interface to the appropriate service instance.