Configuring The Ieee 802.1Ad On Trunk Efp Service Instances - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring the IEEE 802.1ad on Trunk EFP Service Instances

Configuring the IEEE 802.1ad on Trunk EFP Service Instances
Note • Trunk EFP is not supported on S-UNI ports
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ethernet dot1ad {nni | uni {c-port}}
5. service instance [trunk] number ethernet
6. encapsulation dot1q
7. bridge-domin bridge-id from-encapsulation
8. rewrite ingress tag { pop {1 | 2} symmetric
9. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3 interface interface-id
Example:
Router(config)# interface
gigabitethernet0/0/1
Step 4 ethernet dot1ad {nni | uni {c-port}}
Example:
Router(config-if)# ethernet dot1ad nni
or
Router(config-if)# ethernet dot1ad uni
c-port
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
412
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enter global configuration mode.
Enter interface configuration mode. Valid interfaces are physical
ports.
Configures Trunk EFP on dot1ad NNI and C-UNI ports on the
interface.
Note Trunk EFP is not supported on the S-UNI
port.
Configuring IEEE 802.1ad