Configuring Cfm Over Bridge Domains - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet Connectivity Fault Management in a Service Provider Network

Configuring CFM over Bridge Domains

Perform this task to configure Ethernet CFM over bridge domains. This task is optional.
SUMMARY STEPS
1. enable
2. configure terminal
3. ethernet cfm domain domain-name level level-id direction outward
4. service csi-id evc evc-name
5. exit
6. ethernet cfm domain domain-name level level-id
7. exit
8. ethernet cfm domain domain-name level level-id
9. service csi-id evc evc-name
10. mep crosscheck mpid id
11. exit
12. ethernet evc evc-name
13. exit
14. interface type number
15. no ip address
16. service instance id
17. encapsulation dot1q
18. bridge-domain bridge-id
19. cfm mep domain domain-name
20. end
21. configure terminal
22. interface type name
23. no ip address
24. ethernet cfm mip level level-id
25. service instance id
26. encapsulation dot1q
27. bridge-domain bridge-id
28. cfm mep domain domain-name mpid mpid-value
29. end
30. configure terminal
31. ethernet cfm cc enable level level-id
32. ethernet cfm cc level any
33. end
evc-name
evc
ethernet evc-id
vlan-id
mpid mpid-value
ethernet evc-id
vlan-id
evc evc-name
evc evc-name
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
Configuring Ethernet CFM
mac-address
mac
interval seconds loss-threshold num-msgs
197