Configuring the IEEE 802.1ad on Cross-Connect on EFP
encapsulation dot1ad 20-30
rewrite ingress tag pop1 symmetric
bridge-domain from-encapsulation
Configuring the IEEE 802.1ad on Cross-Connect on EFP
• The rewrite push command is supported on C-UNI and S-UNI ports. Rewrite is not supported for
Note
• Only encapsulation default command is supported on S-UNI ports
SUMMARY STEPS
1. enable
2. configure terminal
3. interface interface-id
4. ethernet dot1ad {nni | uni {c-port | s-port}}
5. service instance number ethernet [name]
6. encapsulation {default | dot1q | priority-tagged | untagged}
7. rewrite ingress tag push dot1ad vlan-id [dot1q vlan-id] symmetric}
8. xconnect peer-router-id vcid pw-class pw-class name
9. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface interface-id
Example:
Router(config)# interface
gigabitethernet0/0/1
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
414
NNI ports.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enter global configuration mode.
Enter interface configuration mode. Valid interfaces are physical
ports.
Configuring IEEE 802.1ad