Carrier Ethernet Configuration Guide (Cisco Asr 920 Series - Cisco ASR 920 Series Configuration Manual Ethernet Router

Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Command or Action
Step 13
ethernet cfm traceroute cache hold-time minutes
Example:
Device(config)# ethernet cfm traceroute cache
hold-time 60
Step 14 interface type number
Example:
Device(config)# interface gigabitethernet0/0/1
Step 15 service instance id ethernet [evc-name]
Example:
Device(config-if)# service instance 333 ethernet
evc1
Step 16 encapsulation encapsulation-type
Example:
Device(config-if-srv)# encapsulation dot1q 5
Step 17 bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 100
Step 18 cfm mep domain domain-name mpid id
Example:
Device(config-if-srv)# cfm mep domain L4 mpid
4001
Step 19
end
Example:
Device(config-if-srv)# end
Purpose
Sets the amount of time that CFM traceroute cache entries
are retained.
Specifies an interface and enters interface configuration
mode.
Configures an Ethernet service instance on an interface
and enters Ethernet service configuration mode.
Sets the encapsulation method used by the interface.
Binds a service instance to a bridge domain instance.
Configures the MEP domain and the ID.
Returns to privileged EXEC mode.

Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)

Configuring Ethernet CFM
179