Installing The Gasket; Installation Of High Ip Insert; Through Panel Mounting - Emerson Unidrive M702 User Manual

Safety Product Mechanical
information information installation
Figure 3-31 Installing the gasket
Drive
To seal the space between the drive and the backplate, use two sealing
brackets as shown in Figure 3-32. The sealing brackets are included in
the accessories kitbox supplied with the drive.
Figure 3-32 Through panel mounting
Through panel
securing bracket
Unidrive M702 User Guide
Issue Number: 3
Electrical Getting Basic
installation started parameters
Enclosure
rear wall
Gasket
Enclosure
rear wall
Through panel
securing bracket
Running NV Media Card
Optimization
the motor Operation
Figure 3-33 Installation of high IP insert for size 3
1. To install the high IP insert, firstly place a flat head screwdriver into
the slot highlighted (1).
2. Pull the hinged baffle down to expose the ventilation hole, install the
high IP insert into the ventilation hole in the heatsink (2).
3. Ensure the high IP insert is securely installed by firmly pressing it
into place (3).
4. Close the hinged baffle as shown (1).
To remove the high IP insert, reverse the above instructions.
The guidelines in Table 3-5 should be followed.
Onboard Advanced Technical
Diagnostics
PLC parameters data
UL listing
information
41