Dimensions And Mounting Methods; Surface Mounting - Emerson Unidrive M702 User Manual

Safety Product Mechanical
information information installation
3.5

Dimensions and mounting methods

The drive can be either surface or through-panel mounted using the appropriate brackets. The following drawings show the dimensions of the drive
and mounting holes for each method to allow a backplate to be prepared.
The Through-panel mounting kit is not supplied with the drive and can be purchased separately, below are the relevant part numbers:
Table 3-1 Through-panel mounting kit part numbers
Size
3
4
5
6
7
8
If the drive has been used at high load levels for a period of time, the heatsink can reach temperatures in excess of 70 °C (158 °F). Human
contact with the heatsink should be prevented.
WARNING
Many of the drives in this product range weigh in excess of 15 kg (33 lb). Use appropriate safeguards when lifting these models.
A full list of drive weights can be found in section 12.1.19 Weights on page 237.
WARNING
3.5.1

Surface mounting

Figure 3-15 Surface mounting the size 3 drive
83 mm (3.27 in)
382 mm
(15.04 in)
NOTE
Each mounting bracket contains 4 mounting holes, the outer holes (5.5 mm) x 2 should be used for mounting the drive to the backplate as this allows
the heatsink fan to be replaced without removing the drive from the backplate. The inner holes (6.5 mm) x 2 are used for Unidrive SP size 1 retrofit
applications. See Table 3-2 for further information.
30
Electrical Getting Basic
installation started parameters
CT part number
3470-0053
3470-0056
3470-0067
3470-0055
3470-0079
3470-0083
200 mm (7.87 in)
365 mm
(14.37 in)
Running NV Media Card
Optimization
the motor Operation
Onboard Advanced Technical
PLC parameters data
73.0 mm (2.87 in)
6.0 mm Æ 5.5 mm
40.0 mm
(0.24 in)
(0.22 in)
(1.58 in)
370 mm (14.57 in)
Æ 6.5 mm
(0.26 in)
Unidrive M702 User Guide
UL listing
Diagnostics
information
Issue Number: 3