Keypad Operation; Control Buttons; Getting Started; Understanding The Display - Emerson Unidrive M702 User Manual

Safety Product Mechanical
information information installation
5

Getting started

This chapter introduces the user interfaces, menu structure and security
levels of the drive.
5.1

Understanding the display

The keypad can only be mounted on the drive.
5.1.1 KI-Keypad
The KI-Keypad display consists of two rows of text. The upper row
shows the drive status or the menu and parameter number currently
being viewed. The lower row of the display line shows the parameter
value or the specific trip type. The last two characters on the first row
may display special indications. If more than one of these indications is
active then the indications are prioritized as shown in Table 5-2.
When the drive is powered up the lower row will show the power up
parameter defined by Parameter Displayed At Power-Up (11.022).
Figure 5-1 KI-Keypad
1. Escape button
2. Start reverse (Auxiliary button)
3. Start forward
4. Navigation keys (x4)
5. Stop / Reset (red) button
6. Enter button
NOTE
The red stop button is also used to reset the drive.
The parameter value is correctly displayed in the lower row of the
keypad display, see table below.
Table 5-1 Keypad display formats
Display formats
IP Address
MAC Address
Time
Date
Version number
Character
32 bit number with decimal point
16 bit binary number
88
Electrical Getting Basic
installation started parameters the motor
Value
127.000.000.000
01ABCDEF2345
12:34:56
31-12-11 or 12-31-11
01.02.02.00
ABCD
21474836.47
0100001011100101
Running NV Media Card
Optimization
Operation
Table 5-2 Active action icon
Active action icon
or
5.2

Keypad operation

5.2.1

Control buttons

The keypad consists of:
• Navigation Keys - Used to navigate the parameter structure and
change parameter values.
• Enter / Mode button - Used to toggle between parameter edit and
view mode.
• Escape / Exit button - Used to exit from parameter edit or view
mode. In parameter edit mode, if parameter values are edited and
the exit button pressed the parameter value will be restored to the
value it had on entry to edit mode.
• Start forward button - Use to provide a 'Run' command if keypad
mode is selected.
• Start reverse button - Used to control the drive if keypad mode is
selected and the reverse button is activated. If Enable Auxiliary Key
(06.013) =1, then the keypad reference is toggled between run
forward and run reverse each time the button is pressed. If Enable
Auxiliary Key (06.013) = 2, then the button functions as a run
reverse key.
• Stop / Reset button - Used to reset the drive. In keypad mode can be
used for 'Stop'.
NOTE
Low battery voltage is indicated by
display. Refer to section 3.13.1 Real time clock battery replacement on
page 49 for information on battery replacement.
Figure 5-2 overleaf shows an example on moving between menus and
editing parameters.
Onboard Advanced Technical
Diagnostics
PLC parameters data
Description
Alarm active
Keypad real-time clock battery
low
Accessing non-volatile media
card
Drive security active and locked
or unlocked
Motor map 2 active
User program running
Keypad reference active
low battery symbol on the keypad
Unidrive M702 User Guide
UL listing
information
Priority
Issue Number: 3