Ac Input Current And Fuse Ratings (200 V) - Emerson Unidrive M702 User Manual

Safety Product Mechanical
information information installation
4.8 Ratings
The input current is affected by the supply voltage and impedance.
Typical input current
The values of typical input current are given to aid calculations for power flow and power loss.
The values of typical input current are stated for a balanced supply.
Maximum continuous input current
The values of maximum continuous input current are given to aid the selection of cables and fuses. These values are stated for the worst case
condition with the unusual combination of stiff supply with bad balance. The value stated for the maximum continuous input current would only be
seen in one of the input phases. The current in the other two phases would be significantly lower.
The values of maximum input current are stated for a supply with a 2 % negative phase-sequence imbalance and rated at the supply fault current
given in Table 4-4.
Table 4-4 Supply fault current used to calculate maximum input currents
Model
All
Fuses
The AC supply to the drive must be installed with suitable protection against overload and short-circuits. Table 4-5 shows recommended
fuse ratings. Failure to observe this requirement will cause risk of fire.
WARNING
Table 4-5 AC Input current and fuse ratings (200 V)
Maximum
Typical
continuous
input
Model
current
current
A
03200050 8.2
03200066 9.9
03200080 14
03200106 16
04200137 17
04200185 23
05200250 24
06200330 42
06200440 49
07200610 58
07200750 73
07200830 91
08201160 123
08201320 149
Unidrive M702 User Guide
Issue Number: 3
Electrical Getting Basic
installation started parameters
Symmetrical fault level (kA)
100
Maximum
overload
input input
Nominal
current
A A A
10.4 15.8 16
12.6 20.9
20
17 25
20 34 25
20 30 25
28 41 32
31 52 40
48 64
63
56 85
67 109 80
84 135 100
105 149 125
137 213
200
166 243
Running NV Media Card
Optimization
the motor Operation
IEC
Maximum
Class
A
25 gG
25
gG
32
40 gG
63 gG
80
100 gG
125
200 gR
Onboard Advanced Technical
PLC parameters data
Fuse rating
UL / USA
Nominal Maximum
A
16
20
25
25
30
40
60
70
80
100
125
200
225
UL listing
Diagnostics
information
Class
A
20
CC
or J
25
25
CC
or J
30
CC
40
or J
CC
70
or J
80
CC
100
or J
125
200
HSJ
225
59