Emerson Unidrive M702 User Manual page 95

Safety Product Mechanical
information information installation
Recommended cable
It is recommended that a minimum specification of CAT5e is used in new
installations. If the existing cabling is used this may limit the maximum
data rate depending on the cable ratings. In noisy environments the use
of STP cable will offer additional noise immunity.
Maximum network lengths
The main restriction imposed on the Ethernet cabling is the length of a
single segment of the cable, for Copper - UTP/STP CAT 5 cable type,
maximum trunk cable length should be limited to 100 m. If distances
greater than this are required it may be possible to extend the network
with additional switches.
Ethernet set-up parameters
The following section covers the minimum number of parameters
required to be set to establish an Ethernet communication.
Table 5-9 Key to parameter table coding
RW Read / Write
RO Read only
Num Number parameter
Bit Bit parameter
Txt Text string
Bin Binary parameter
FI Filtered
IP IP Address
Date Date parameter
4.00.007
Reset
{24.007}
RW Bit
Off (0) or On (1)
Changes to the Ethernet set-up parameters will not take effect until a
Reset (4.00.007) has been performed.
4.00.010 Active IP Address
RO IP
000.000.000.000 to
255.255.255.255
This parameter displays the Active IP Address. The Active IP Address
can also be viewed in Pr 00.037.
4.02.005 DHCP Enable
RW Bit
Off (0) or On (1)
If DHCP Enable (4.02.005) is set to On (1), the IP address is acquired
from the DHCP server and written to IP Address (4.02.006).
NOTE
When using manual / static IP address configuration, ensure Subnet
Mask (4.02.007) and Default Gateway (4.02.008) should also be set
manually.
4.02.006 IP Address
RW IP
000.000.000.000 to
255.255.255.255
Unidrive M702 User Guide
Issue Number: 3
Electrical Getting Basic
installation started parameters the motor
ND No default value
NC Not copied
PT Protected parameter
RA Rating dependant
US User save
PS Power-down save
DE Destination
Mac Mac Address
Time Time parameter
US
Off (0)
US
US
On (1)
US
192.168.001.100
Running NV Media Card
Optimization
Operation
This parameter controls and displays the IP address of the drive. If
DHCP Enable (4.02.005) is set to On (1) this parameter will become
read-only.
4.02.007 Subnet Mask
RW IP
000.000.000.000 to
255.255.255.255
This parameter controls and displays the Subnet Mask (4.02.007) of the
drive.
4.02.008 Default Gateway
RW IP
000.000.000.000 to
255.255.255.255
This parameter controls and displays the Default Gateway (4.02.008) of
the drive.
PC Tools support
The discovery protocol feature, which is supported by the Unidrive M PC
tools, is able to discover the drives that are connected to a PC,
independent of above parameter settings.
Onboard Advanced Technical
Diagnostics
PLC parameters data
255.255.255.000
192.168.1.254
UL listing
information
US
US
95