Dimensions And Mounting Methods - Emerson E300 Installation And Commissioning Manual

Safety Product
information information
3.5

Dimensions and mounting methods

The drive can be either surface or through-panel mounted using the appropriate brackets. The following drawings show the dimensions of the drive
and mounting holes for each method to allow a back plate to be prepared. The Through-panel mounting kit is not supplied with the drive and can be
purchased separately. The relevant part numbers are shown the table below.
Table 3-2 Through-panel mounting kit part number numbers for size 3 to 7
Size
3
4
5
6
7
If the drive has been used at high load levels for a period of time, the heatsink can reach temperatures in excess of 70 °C (158 °F).
Human contact with the heatsink should be prevented.
WARNING
Many of the drives in this product range weigh in excess of 15 kg (33 lb). Use appropriate safeguards when lifting these models.
WARNING
3.5.1 Surface mounting
Figure 3-9 Drive dimensions, Surface mount (size 3 to 7)
Size
3
4
5
6
7
NOTE
Each mounting bracket contains 4 mounting holes. The outer holes (5.5 mm) x 2 should be used for mounting the drive to the backplate, as this
allows the heatsink fan to be replaced without removing the drive from the backplate. The inner holes (6.5 mm) x 2 are used for Unidrive SP size 1
retro fit applications.
E300 Installation and Commissioning Guide
Issue Number: 1
Mechanical Electrical
installation installation
CT part number
3470-0053
3470-0056
3470-0067
3470-0055
3470-0079
B
C
A
A
mm in mm
382 15.04
391 15.39 365
389 15.32
508 20.0 508
Getting
User Menu A Commissioning
started
D
B
in mm
83
124
14.37
143
210
20 270
Optimization
C D
in mm
3.27
200
4.88
5.63 202
8.27 227
10.63 279
Diagnostics
in
7.87
7.95
8.94
11
25