Number Of Paper Feeding Retries - Fujitsu fi-7160 Operator's Manual

Chapter 8 Operational Settings
3
Specify whether or not to enable pre-pick.
Select [Yes] or [No].
HINT
 If you cancel in the middle of scanning while pre-pick is
enabled, you will have to remove the pre-picked document,
then load the document again.
 This setting can also be configured in the scanner driver or with
the operator panel. Note that priority is given to the scanner
driver setting.

Number of Paper Feeding Retries

Configure this setting to change the number of feeding retries
when a pick error occurs.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 143).
2
From the listing on the left, select [Device Setting 2] 
[Number of paper feeding retries].
3
Specify the number of paper feeding retries.
The value can range from 1 to 12 times.
HINT
This setting can also be configured with the operator panel.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
168