Operational - Fujitsu fi-7160 Operator's Manual

Chapter 6 Replacing the Consumables
6
Attach the two new pick rollers on the shaft one at a time.
1 Insert the retaining clip of the pick roller into the slot.
2 Insert the retaining clip of the other pick roller into the slot.
ATTENTION
Confirm that the pick roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
Make sure to insert the pick roller until it locks in place.
7
Attach the shaft.
1 Insert the left end of the shaft into the slot, and lower the other end
Pick Roller
Retaining Clip
Shaft
Slot
Pick Roller
Retaining Clip
2 Rotate the bushing on the shaft in the direction of the arrow.
Shaft
Slot
3 Close the sheet guide. Make sure that both ends of the sheet guide
ATTENTION
Confirm that the pick roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
gradually.
are locked firmly.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Shaft
Various Ways to
Scan
Daily Care
Bushing Replacing the
Consumables
Shaft
Troubleshooting

Operational

Settings
Appendix
Glossary
107