Settings Related To Multifeed Detection - Fujitsu fi-7160 Operator's Manual

Chapter 8 Operational Settings

8.6 Settings Related to Multifeed Detection

Specifying a Multifeed Detection Method
[Multifeed]
Multifeed is an error where two or more sheets are fed through
the ADF at once. When a different document length is
detected, this detected result is also called a multifeed.
Not noticing multifeed errors while scanning may put you in a
situation where important data are missing from the scanned
images.
Multifeed detection can be used to prevent such troubles.
When this function is enabled, an error message is displayed
as soon as it detects a multifeed, and stops the scan. Note
that multifeed cannot be detected within 30 mm from the
leading edge of the document.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 143).
2
From the listing on the left, select [Device Setting 2] 
[Multifeed].
3
Select a detection method.
Method
None Does not detect multifeed.
Check Detects multifeed by the overlapping of
Overlapping documents.
(Ultrasonic) When this is selected, you can also specify the
following two options:
 Specify the detection range by the length from
the top of the document.
Proceed to
Multifeed [Document check area specification
for Multifeed Detection]" (page 178)
details.
 Ignore the multifeed when there is paper of the
same size attached to a designated location
on the page.
Proceed to
Pattern" (page 86)
Description
"Specifying the Area to Detect
for more
"Ignoring Multifeed for a Set
for more details.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
176