Operational - Fujitsu fi-7160 Operator's Manual

Chapter 4 Various Ways to Scan
2
Press the [] or [] button and select a parameter, then
press the [Scan/Enter] button to confirm.
Configure the application you want to launch when you press the
[Scan/Enter] button while the [Ready] screen is displayed.
Parameters in the [Function Selection] screen, application numbers in
the indicator, and events configured on the computer correspond to
one another as follows:
Parameter in Application number
the [Function in the indicator
Selection]
screen
No.00 F00
No.01 to No.50 F01 to F50
SOP SOP
As an example, the following indicator displays an application number
"F02". This number is displayed by selecting [No.02] in the [Function
Selection] screen and performs the [Send to 2] event configured on
the computer.
3
Press the [Scan/Enter] button.
The specified application is launched.
Ignoring Multifeed for a Set Pattern
If you attempt to scan a document with an attachment such as
sticky note, receipt, or photo while multifeed detection is
enabled, the scanner may falsely recognize this as a multifeed
error and stop the scan. To scan these types of documents,
the "Intelligent Multifeed Function" is available.
Event configured on
There are two modes in this function. In one mode, you can
the computer
suppress multifeeds forcibly by using the operator panel on
the scanner. In the other mode, you can suppress multifeeds
[Scan Button]
automatically by letting the scanner memorize the location and
the length of the attachment.
[Send to 1] to [Send to
50]
N/A
Sticky Note
Receipt
or Photograph
Document
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
86