Operational - Fujitsu fi-7160 Operator's Manual

Image scanner
Hide thumbs Also See for fi-7160:
Table of Contents

Advertisement

Chapter 4 Various Ways to Scan
 Auto mode 2 (Bypass by length)
Memorizes the length of the longest paper attachment that was
detected as multifeed, and continues scanning. When a paper
attachment of the same length or shorter is detected, multifeed
detection is automatically suppressed.(*1)(*2)
*1: Eight overlap patterns can be memorized in this mode.
When it exceeds this limit, the first pattern that was memorized
is erased from the memory.
*2: To erase the memorized overlap patterns and the longest
overlap length, use [12: iMFF Setting] on the [Settings Menu]
screen of the operator panel, or Software Operation Panel.
After erasing is completed, the indication on the LCD changes
to
or
patterns and the longest overlap length that were not
supposed to be memorized. Be careful with this operation
because all memorized patterns will be erased.
. This allows you to erase multifeed
Disabling Paper Protection for a Single Scan
After Paper Protection Is Set Off
If you attempt to scan a wrinkled document while paper
protection is on, the scanner may detect it as a paper jam,
which causes paper protection to be set off and forces a scan
to be stopped even though paper is fed normally. In this case,
you can disable paper protection on the operator panel for a
single scan after paper protection is set off.
Operational Procedure
LCD
[Menu] Button
[Scan/Enter] Button
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fi-7480Fi-7460

Table of Contents