Operational - Fujitsu fi-7160 Operator's Manual

Chapter 7 Troubleshooting
Error Error messages
code
U6:B4 Print cartridge not This error is related to the imprinter.
installed For details, refer to the fi-748PRB
Check if the Print Imprinter Operator's Guide.
Cartridge is
mounted
correctly.
(only when the
imprinter is
installed)
*1: When you open the ADF while the scanner is in standby, only an error
message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
ADF is open.
*2: When you open the imprinter print section while the scanner is in
standby, only an error message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
imprinter print section is open.
Device Errors
Action
The following are lists of device errors which require
troubleshooting by a service engineer.
■
Internal and Optical Errors
Error codes beginning with the letter "E" are displayed.
Error
code
E2:74
E3:75
Error messages
Optical error (ADF 1 Clean the glass section.
Front) For details, refer to
If the problem persists Daily Care" (page
after turning the power
2 Turn the scanner off then back on.
back on, please inform
If the problem persists, write
your service provider
down the displayed error code
of the above error
and contact your FUJITSU
code.
scanner dealer or an authorized
FUJITSU scanner service
Optical error (ADF
provider.
Back)
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Action
Documents
How to Use the
"Chapter 5
Operator Panel
91).
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
115