Operational - Fujitsu fi-7160 Operator's Manual

Chapter 4 Various Ways to Scan
1
After paper protection is set off, open the ADF and
remove the document.
After the document is removed, indication on the LCD of the operator
panel changes as follows:
When paper protection is set off
Paper protection (feeding noise)
Remove and check the document, and
then try again carefully.
Paper protection (feeding accuracy)
Remove and check the document, and
then try again carefully.
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
2
If you open the ADF to remove the document, close it.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to get your fingers caught
when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, the document
may not be fed into the ADF.
3
Load the documents back in the ADF paper chute
(feeder).
4
When a document is
ejected
Disable paper
protection.
--------------------------------
Enable:Scan
(Switch:Menu)
21).
Press the [Menu] button and confirm that the LCD displays
[Disable], and then either press the [Scan/Enter] button or
perform a scan from the computer.
From this point, note that the indication on the LCD switches between
[Enable][Disable] every time you press the [Menu] button. When
[Disable] is displayed, the next document is scanned with paper
protection disabled. After that, the subsequent documents are
scanned according to the paper protection setting of either scanner
driver, Software Operation Panel, or operator panel.
HINT
If paper protection is set off frequently, refer to
set off frequently." (page 133).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
"Paper protection is
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
90