Basic Flow Of Scanning Operation - Fujitsu fi-7160 Operator's Manual

Chapter 1 Scanner Overview

1.8 Basic Flow of Scanning Operation

This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
The following scanner drivers and image scanning
applications are bundled with the scanner:
 Scanner driver
- PaperStream IP (TWAIN)
- PaperStream IP (TWAIN x64)
- PaperStream IP (ISIS) Bundle
 Image scanning application
- PaperStream Capture
- ScanSnap Manager for fi Series
HINT
For details about the scanner drivers and image scanning applications,
refer to "1.9 Bundled Software" (page 30).
Scanning procedures and operations slightly vary depending
on the image scanning application.
For details, refer to the image scanning application manual.
The following describes the normal procedure for scanning.
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2
Load a document in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
For details, refer to "Chapter 2 How to Load Documents" (page
3
Start an image scanning application.
4
Select a scanner driver.
For some image scanning applications, selection of a scanner driver
may not be needed.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
19).
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
34).
Operational
Settings
Appendix
Glossary
28