Chapter 5 Daily Care
Feed Roller (× 2)/Eject Roller (× 2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page
The [Ready] screen is displayed on the LCD.
2 Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
[] or []
3 Press the
button and select [2: Cleaning], then press
the [Scan/Enter] button to confirm.
The [Cleaning] screen is displayed on the LCD.
[] or []
4 Press the
button and select [2: Roller Wipe], then
press the [Scan/Enter] button to confirm.
A message is displayed on the LCD.
ATTENTION
Do not perform scanning from the scanner driver during
cleaning.
5 Open the ADF.
For details, refer to
"1.4 Opening/Closing the ADF" (page
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
6 When you press the [Scan/Enter] button, the feed/eject rollers
rotate a certain amount.
19).
21).
7 Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the roller surface, and wipe horizontally.
Wipe off any dirt or dust on the surface by pressing the [Scan/
Enter] button to rotate the rollers.
Make sure that it is wiped properly because black residue on the
roller will affect the feeding performance.
As a guideline, pressing the [Scan/Enter] button seven times will
rotate the feed/eject rollers one revolution.
[Scan/Enter] Button
When you press the [Scan/Enter] button,
the feed/eject rollers rotate at the same
time. Be careful not to touch the rollers
with your hand while they are rotating.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
99