Operational - Fujitsu fi-7160 Operator's Manual

Image scanner
Hide thumbs Also See for fi-7160:
Table of Contents

Advertisement

Chapter 8 Operational Settings
8.8 Settings Related to Power ON/OFF
Method of Turning the Scanner ON/OFF [Power
SW Control]
The method by which the scanner is powered on/off can be
specified from one of the following:
 Press the [Power] button on the operator panel
 Use an AC power strip to control power supply for peripherals such
as a scanner in accordance with the computer's power.
 Turn on/off the scanner in accordance with the computer's power.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
(page
143).
2
From the listing on the left, select [Device Setting 2] 
[Power SW Control].
3
Select one of the following:
[Enable power switch]: Press the [Power] button on the operator
panel.
[Disable power switch]: Use an AC power strip to control the power
supply for peripherals such as a scanner in
accordance with the computer's power.
[Enable USB power feeding]: Turn on/off the scanner in accordance
with the computer's power.
ATTENTION
 When you select [Disable power switch], the scanner is not
turned off even if the [Power off after a certain period of time]
check box is selected in [Device Setting] on the Software
Operation Panel.
 Some types of computers and USB hubs keep supplying power
to the USB bus even after the computer is turned off.
In that case, the [Enable USB power feeding] mode may not
work properly.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
185

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fi-7480Fi-7460

Table of Contents