Operational - Fujitsu fi-7160 Operator's Manual

Chapter 8 Operational Settings
Item
Multifeed
(page 176)
Page Edge Filler (ADF)
(page 165)
Dropout color
(page 166)
Pre-Pick
(page 167)
Description
Specify a method for multifeed detection. Detect
multifeeds by monitoring the overlap, document
length, or the combination of both.
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Specify a width for the margin around the
scanned image to fill the margin in white or
black.
The specified area is filled in white or black,
according to the background color.
This setting can also be configured in the
scanner driver. In that case, Page Edge Filler of
the scanner driver is used on the output image.
Select a color to be removed from the scanned
image (only available in black & white or
grayscale mode).
This setting can also be configured in the
scanner driver. Note that priority is given to the
scanner driver setting.
Select [Yes] to prioritize the processing speed.
Otherwise, select [No].
This setting can also be configured in the
scanner driver or with the operator panel. Note
that priority is given to the scanner driver
setting.
Parameter/Value
None/Check Overlapping (Ultrasonic)/Check
Length/Check Overlapping and Length
Length (When [Check Length] is specified:
Select from 10/15/20 mm)
Top/Left/Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1)
(A: image, B: filled area, A+B: output)
Red/Green/Blue/None
Yes/No
TOP
Contents
Factory Default
Index
None
Introduction
Length: 10 mm
Scanner
Overview
How to Load
Top/Bottom/Left/
Documents
Right: 0 mm
How to Use the
Operator Panel
Various Ways to
Scan
Green
Daily Care
Replacing the
Consumables
Yes
Troubleshooting

Operational

Settings
Appendix
Glossary
154