Operator Panel - Fujitsu fi-7160 Operator's Manual

Chapter 3 How to Use the Operator Panel

3.1 Operator Panel

The operator panel consists of an LCD, buttons and an LED indicator.
Names and Functions
[Menu] Button
Configures various types of scanning operations.
Determines whether or not to memorize the pattern if pressed
when a multifeed occurs.
Determines whether to enable or disable paper protection if
pressed when a scanning operation is stopped due to paper
protection.
[Power] Button
Turns the power on/off.
Lights in green when the scanner is turned on.
*1: For details about setup method for a scan using the [Scan/Enter] button, refer to the scanner driver's Help or
Scanning" (page 84).
*2: Pressing the [Scan/Enter] button when scanning a document with ScanSnap Manager for fi Series cancels the scanning process, after the document
is scanned.
LCD
Indicates the status of the scanner.
Switches off when the scanner enters power saving mode.
LED Indicator
Lights in orange when an error occurs.
Flashes when the ADF is open or consumables reach the end of their life cycle.
[Stop/Clear] Button
Stops the scan immediately.
Cancels the selected item and returns to the previous screen. Clears the displayed
error indication.
Resets the page counter when pressed down for three seconds or longer.
[Scan/Enter] Button (*1)
Launches the linked application software.
Confirms the selected item.
Pauses the scan (*2). Resumes the paused scan.
Ejects the document when a multifeed occurs.
[]/[] Button
Switches the number (No.00 to No.50/SOP) for the application that is launched when
the [Scan/Enter] button is pressed while the [Ready] screen is displayed.
Switches the selected item.
"Using a Button on the Scanner to Start
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
51