Operational - Fujitsu fi-7160 Operator's Manual

Chapter 4 Various Ways to Scan
2
Load the document folded in half in the ADF paper chute
(feeder).
Secure the document folded in half with the side guides to avoid
skewing.
3
Slide the feed mode switch left to switch the feed mode to
Manual/Single mode.
Feed Mode Switch
The following screen is displayed on the LCD of the operator panel.
4
Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
ATTENTION
 Operating the feed mode switch during a scan causes an error.
 Setting the feed mode switch to Manual/Single mode disables
[Check Overlapping (Ultrasonic)] in the multifeed detection
setting.
HINT
The scanner will wait for the next document to be loaded until the
time specified for the Timeout time elapses, even if there is no
document in the ADF paper chute (feeder).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
79