Operational - Fujitsu fi-7160 Operator's Manual

Chapter 5 Daily Care
Brake Roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to
Brake Roller" (page 103).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick Roller (× 2)
Gently wipe off any dirt or dust along the grooves as you rotate the roller
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Rubber Roller (× 4)
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Be careful not to damage the sponge that is attached to the roller.
Glass (× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
Ultrasonic Sensor (× 2)/Document Sensor (× 8)
Gently wipe the dirt and dust off the surface of the ultrasonic/document
"6.2 Replacing the
sensors.
HINT
If it is difficult to clean, use a cotton swab.
Ultrasonic Sensor
Contents
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Document Sensor
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
TOP
Index
98