Operational - Fujitsu fi-7160 Operator's Manual

Chapter 3 How to Use the Operator Panel
Item
17: Vertical Streak Select whether to enable or disable vertical streak
Detection detection.
After enabling this setting,
LCD when a vertical streak may occur in the images
that are scanned through the ADF.
[Clean glass!] also flashes on the second line in the
[Ready] screen.
Check the information, and then clean the glass.
For details about checking the information, refer to
"Checking the Information" (page
For details about cleaning, refer to
Care" (page
Specify the sensitivity level to detect vertical streaks
(dirt on the glass) when vertical streak detection is
enabled.
Select [1: Low] to only detect large amounts of dirt
on the glass. Select [3: High] to also detect small
amounts of dirt on the glass.
Enable/Disable can also be configured in the
scanner driver or the Software Operation Panel.
Sensitivity can also be specified in the Software
Operation Panel.
18: Prioritize Panel For the paper protection setting, prioritize the
Settings operator panel setting over the Software Operation
Panel setting. You cannot prioritize the operator
panel setting over the scanner driver setting.
When [1: Paper Protection] is selected, the Paper
Protection setting of the operator panel is
prioritized.
When [2: Clear] is selected, the Paper Protection
setting is no longer prioritized.
Description
flashes on the
60).
"Chapter 5 Daily
91).
Parameter (*1)/Value
-: No parameters/values
1: Enable
2: Disable
Sensitivity:
1: Low
2: Normal
3: High
1: Paper Protection
2: Clear
TOP
Contents
Factory
Index
Default
(*2)
Introduction
Scanner
2: Disable Overview
How to Load
Sensitivity:
Documents
2: Normal
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
2: Clear

Operational

Settings
Appendix
Glossary
71