Scanner Cleaning Cycle [Cleaning Cycle] - Fujitsu fi-7160 Operator's Manual

Chapter 8 Operational Settings

Scanner Cleaning Cycle [Cleaning Cycle]

The cleaning cycle for the scanner can be specified.
The background color of the cleaning counter in [Device
Setting] turns yellow when the sheet count after cleaning is
performed reaches 100% of the specified value.
You can also display a cleaning instruction message
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 143).
2
From the listing on the left, select [Device Setting 2] 
[Cleaning Cycle].
3
Specify a value for the cleaning cycle.
The value can range from 1,000 to 255,000 sheets (in increments of
1,000).
Specify whether or not to display the cleaning instruction message.
Replacement Cycle of Consumables [Life
Counter Alarm Setting]
The replacement cycle for each consumable can be specified.
The background color of the brake roller/pick roller counter in
[Device Setting] changes to light yellow when the sheet count
(page 161).
after a consumable replacement reaches 95% of the value
specified here, and turns yellow when the sheet count reaches
100%.
A message for replacing a consumable
appears.
1
Start up the Software Operation Panel.
For details, refer to
(page
2
From the listing on the left, select [Device Setting 2] 
[Life Counter Alarm Setting].
"8.1 Starting Up the Software Operation Panel"
143).
Contents
Introduction
Scanner
Overview
How to Load
Documents
(page 161) also
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
162