Power Saving Mode; Operational - Fujitsu fi-7160 Operator's Manual

Chapter 1 Scanner Overview

1.7 Power Saving Mode

Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes (factory default
setting) without being used, it automatically enters power
saving mode.
When the scanner enters power saving mode, the LCD on the
operator panel switches off. The [Power] button flashes in
green.
To resume from power saving mode, perform one of the
following:
 Load a document in the ADF paper chute (feeder)
 Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will
turn the power off.
 Perform scanning from an application
The scanner is turned off automatically if it is left on for a
certain period of time without being used, reducing the power
consumption until the next scan.
To prevent the scanner from being turned off automatically,
clear the [Power off after a certain period of time] check box in
[Device Setting] on the Software Operation Panel. For details,
refer to "Waiting Time for the Scanner to Enter Power Saving
Mode [Power saving]" (page 184).
To turn the power back on after the power is turned off
automatically, press the [Power] button on the operator panel.
For details, refer to "1.3 Turning the Power ON/OFF" (page
19).
ATTENTION
 The scanner may not enter power saving mode if there is a
document remaining on the paper path. In this case, remove the
document.
For details, refer to "7.1 Paper Jam" (page
 For some applications, the scanner may not be turned off even if the
[Power off after a certain period of time] check box is selected.
 If the scanner is automatically turned off while you are using the
image scanning application, exit the application, and then turn the
power on.
HINT
 By using one of the following, you can change the waiting time for
the scanner to enter power saving mode.
- Use the Operation Panel ([20: Power saving] in the [Settings
Menu] screen).
For details, refer to "3.2 Settings Menu" (page
- Use the Software Operation Panel.
For details, refer to "Waiting Time for the Scanner to Enter Power
Saving Mode [Power saving]" (page
 For details about the operator panel, refer to
the Operator Panel" (page 50).
110).
55).
184).
"Chapter 3 How to Use
Troubleshooting
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables

Operational

Settings
Appendix
Glossary
27