An Error (Error Code "U4:40" Or "U5:4A") Is Already Displayed In The Lcd After Power-On; How To Use The Operator Panel - Fujitsu fi-7160 Operator's Manual

Chapter 7 Troubleshooting
An error (error code "U4:40" or "U5:4A") is
already displayed in the LCD after power-on.
Does the problem persist after turning the power off then
back on?
Yes
Is error code "U4:40" or "U5:4A" displayed in the LCD
while the LED indicator is flashing?
No
The scanner is operating correctly.
No
Close the ADF and the print section of the imprinter (only when the imprinter is
installed) properly.
Yes
For details, refer to "1.4 Opening/Closing the ADF" (page
If the indication does not return to the [Ready] screen after you closed the ADF,
check the items in "7.4 Before You Contact the Scanner Service Provider" (page
139) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU
scanner service provider.
If the problem persists, check the items in
Service Provider" (page 139)
an authorized FUJITSU scanner service provider.
21).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
129