The Lcd Or The [Power] Button Light Or Both Switch Off - Fujitsu fi-7160 Operator's Manual

Chapter 7 Troubleshooting
The LCD or the [Power] button light or both
switch OFF.
Has the scanner been left out of operation for a long time
after being powered on?
No
Do the LCD and the [Power] button light remain off even if
you turn the scanner off and then on again?
Yes
The scanner has entered power saving mode or has been automatically turned off.
 If the scanner has entered power saving mode
Yes
The LCD turns off and the [Power] button flashes in green.
Resume from power saving mode by one of the following methods:
- Load a document in the ADF paper chute (feeder)
- Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will turn the
power off.
- Perform scanning from an application
 If the scanner has been automatically turned off
The LCD and the [Power] button light are off.
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
The scanner is operating correctly.
No
If the problem persists, check the items in
Service Provider" (page 139)
an authorized FUJITSU scanner service provider.
19).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
122