The Function Number Display Or The [Power] Button Or Both Switch Off - Fujitsu fi-7140 Operator's Manual

Chapter 7 Troubleshooting
The Function Number Display or the [Power]
button or both switch off.
Has the scanner been left out of operation for a long time
after being powered on?
No
Does the Function Number Display and the [Power] button
light remain off even if you turn the scanner off and then on
again?
Yes
The scanner has entered power saving mode or has been automatically turned off.
 If the scanner has entered power saving mode
Yes
The Function Number Display turns off but the [Power] button light remains
green.
Resume from power saving mode by one of the following methods:
- Load a document in the ADF paper chute (feeder)
- Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will turn the
power off.
- Perform scanning from an application
 If the scanner has been automatically turned off
The Function Number Display and the [Power] button light are off.
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
The scanner is operating correctly.
No
If the problem persists, check the items in
Service Provider" (page 119)
an authorized FUJITSU scanner service provider.
23).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
101