Remove the accelerator cages
Use the appropriate procedure for the accelerator cage procedure being performed.
Remove the upper server tray
Power down the server (on page 28).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server (on page 28).
3.
Place the server on a flat, level work surface.
4.
Disconnect the intra-tray signal cable from the power expander board.
5.
Remove all drives from drive cage assembly 2
6.
Remove drive cage assembly 2
7.
Disconnect and remove the drive cables connected to drive cage assembly 2
8.
page 91).
Disconnect all accelerator cables from the power expander board
9.
page 94).
Remove the accelerator cages (on page 29).
10.
("Removing and replacing a
("Drive cage assembly
2" on page 58).
drive" on page 35).
("Drive
("Accelerator option
Removal and replacement procedures 29
cabling" on
cabling" on