Dimms - HPE ProLiant XL250a Gen9 Maintenance And Service Manual

DIMMs

To remove the component:
Power down the server (on page 28).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server (on page 28).
3.
Place the server on a flat, level work surface.
4.
Disconnect the intra-tray signal cable from the power expander board.
5.
Remove all drives from drive cage assembly 2
6.
Remove drive cage assembly 2
7.
Disconnect and remove the drive cables connected to drive cage assembly 2
8.
page 91).
Remove the rear accelerator cage
9.
Remove the front accelerator cage
10.
Disconnect all accelerator cables from the power expander board
11.
page 94).
Remove the upper server tray (on page 29).
12.
Remove the processor air baffle
13.
("Removing and replacing a
("Drive cage assembly 2" on page 58).
("Accelerator (rear)" on page 44).
("Accelerator (front)" on page 40).
("Processor air baffle" on page 46).
drive" on page 35).
("Drive
("Accelerator option
Removal and replacement procedures 48
cabling" on
cabling" on