Re-Entering The Server Serial Number And Product Id - HPE ProLiant XL250a Gen9 Maintenance And Service Manual

While aligning the upper server tray for installation, feed the the intra-tray signal cable and the drive
10.
cable up through the space indicated for the cable routing. For information on routing the intra-tray
signal cable, see "Intra-tray signal cable routing (on page 94)." For information on routing the drive
cables, see "Drive cabling (on page 91)."
Install the upper server tray (on page 31).
11.
Connect the intra-tray signal cable to the power expander board.
12.
Remove the upper tray support bracket
13.
30).
Connect and route all accelerator cables to the power expander board
14.
on page 94).
Install the upper server tray support bracket (on page 30).
15.
Install the rear accelerator cage
16.
Install the front accelerator cage
17.
Connect and route all cables for drive cage assembly 2
18.
Install drive cage assembly 2
19.
Install all drives
20.
Install the server into the chassis
21.
Connect all peripheral cables to the server.
22.
Press the Power On/Standby button.
23.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.

Re-entering the server serial number and product ID

IMPORTANT: When re-entering the serial number, be sure to use the server serial number.
This number is located on the front panel serial number/iLO information pull tab
components" on page 83). Do not use the chassis serial number.
After you replace the system board, you must re-enter the server serial number and the product ID.
During the server startup sequence, press the F9 key to access RBSU.
1.
Select the Advanced Options menu.
2.
Select Service Options.
3.
("Accelerator
("Accelerator
("Drive cage assembly
("Removing and replacing a
("Install the
("Remove the upper server tray support
(rear)" on page 44).
(front)" on page 40).
("Drive cabling" on page 91).
2" on page 58).
drive" on page 35).
server" on page 33).
Removal and replacement procedures 74
bracket" on page
("Accelerator option cabling"
("Front panel