Using a T-10 Torx screwdriver, remove the drive cage assembly.
18.
To replace the component, reverse the removal procedure.
Drive cage assembly 2
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 28).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page 28).
4.
Place the server on a flat, level work surface.
5.
Remove all drives from drive cage assembly 2
6.
Using a T-10 Torx screwdriver, remove the drive cage assembly.
7.
Disconnect and remove the drive cables connected to drive cage assembly 2
8.
page 91).
("Removing and replacing a
Removal and replacement procedures 58
drive" on page 35).
("Drive
cabling" on