To remove the component:
Power down the server (on page 28).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server (on page 28).
3.
Place the server on a flat, level work surface.
4.
Locate the battery on the system board
5.
Remove the battery.
6.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through RBSU.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Heatsink
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
To remove the component:
Power down the server (on page 28).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server (on page 28).
3.
Place the server on a flat, level work surface.
4.
("System board
components" on page 86).
Removal and replacement procedures 61