Drive Cage Assembly 1 - HPE ProLiant XL250a Gen9 Maintenance And Service Manual

Drive cage assembly 1

To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 28).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page 28).
4.
Place the server on a flat, level work surface.
5.
Disconnect the intra-tray signal cable from the power expander board.
6.
Remove all drives from drive cage assembly 2
7.
Remove drive cage assembly 2
8.
Disconnect and remove the drive cables connected to drive cage assembly 2
9.
page 91).
Remove the rear accelerator cage
10.
Remove the front accelerator cage
11.
Disconnect all accelerator cables from the power expander board
12.
page 94).
Remove the upper server tray (on page 29).
13.
Remove the PCIe riser board assembly
14.
("Removing and replacing a
("Drive cage assembly 2" on page 58).
("Accelerator (rear)" on page 44).
("Accelerator (front)" on page 40).
("PCIe riser board
drive" on page 35).
("Drive
("Accelerator option
assembly" on page 50).
Removal and replacement procedures 56
cabling" on
cabling" on