Table of Contents
Advertisement
Remove the FlexibleLOM adapter from the FlexibleLOM slot on the PCIe/FlexibleLOM riser.
5.
To replace the component, reverse the removal procedure.
HPE Ethernet Dual 1Gb 1-port 364i Adapter and I/O
module
I/O modules are specific to each server and are installed in the rear of the chassis. The chassis has ten
I/O module bays located in the rear of the chassis. I/O module blanks are supported in all even-numbered
bays and I/O modules are supported in all odd-numbered bays.
To remove the component:
Power down the server associated with the I/O module
1.
Remove the server associated with the I/O module
2.
If an I/O module blank is not installed in the associated even-numbered I/O module bay, install an I/O
3.
module blank in the associated even-numbered bay.
("Power down the
server" on page 28).
("Remove the
server" on page 28).
Removal and replacement procedures 38
Advertisement
Table of Contents
