Table of Contents
Advertisement
IMPORTANT: When installing a HPE ProLiant XL250a Gen9 Server, be sure that only I/O
module blanks are installed in the even-numbered I/O module bays. Failure to do so may
cause the I/O modules in the even-numbered bays to disengage or to be damaged.
Prepare the server for installation.
1.
Install the server. When seated properly, the server will be flush with the front of the chassis and the
2.
release lever will close completely without resistance.
Press the Power On/Standby button.
3.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
Removal and replacement procedures 34
Advertisement
Table of Contents
