Remove the DIMM.
14.
To replace the component, reverse the removal procedure.
Rear PCIe riser board
To remove the component:
Power down the server (on page 28).
1.
Disconnect all peripheral cables from the server.
2.
Remove the server (on page 28).
3.
Place the server on a flat, level work surface.
4.
Disconnect the intra-tray signal cable from the power expander board.
5.
Remove all drives from drive cage assembly 2
6.
Remove drive cage assembly 2
7.
Disconnect and remove the drive cables connected to drive cage assembly 2
8.
page 91).
("Removing and replacing a
("Drive cage assembly
2" on page 58).
drive" on page 35).
("Drive
Removal and replacement procedures 49
cabling" on