Normal Mode Commands - Rice Lake IQ plus 710 Installation Manual

Command
DIGIN1 Digital input function
DIGIN2
DIGIN3
DIGIN4
DIGIN5
DIGIN6
DIGIN7
DIGIN8
Discontinued Product
Command
SOURCE1 Analog output source
OFFSET Zero offset
ERRACT Error action
MIN Minimum value tracked
MAX Maximum value tracked
ZERO1 Zero calibration
SPAN1 Span calibration
5.1.5

Normal Mode Commands

The normal mode commands (see Table 5-13) transmit data to the EDP port on demand. The SX command is
valid only in normal operating mode; all other commands are valid in either setup or normal mode.
Command
CONSNUM Set consecutive number
UID Set unit ID
SD Set date
ST Set time
SX Start EDP streaming
EX Stop EDP streaming
DX Start streaming raw A/D counts
RS Reset system
XA Transmit accumulator value
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions
46 IQ plus 710 Installation Manual
Description
OFF, ZERO, NT/GRS, TARE, UNITS, PRINT, ACCUM, SETPNT,
TIMDATE, ESC, ALPHAMD, CLEAR, DSPTAR, IDKEY, KF1–KF4,
KEY0–KEY9, KEYDP, ENTER, BATRUN, BATSTRT, BATPAUS,
KBDLOC, HOLD, CLRCN, GROSS, NET, PRIM, SEC, TIME, DATE,
CLRTAR, CLRACC
Table 5-11. DIG IN EDP Commands
Description
GROSS, NET
0%, 20%
FULLSC, HOLD, ZEROSC
0–9 999 999
0–9 999 999
0–16 383
0–16 383
Table 5-12. ALGOUT EDP Commands
Description
Table 5-13. Normal Mode EDP Commands
Values
Values
Response Format
0–9 999 999
nnnnnnn
MMDDYY, DDMMYY, YYMMDD (enter using DATEFMT
specified)
hhmm (enter using 24-hour format)
OK or ??
OK or ??
OK or ??
—
nnnnnn UU
where nnnnnn is the weight value, UU is the units.
nnnnn
See Section 10.1 on page 65 for detailed information about
the XE command response format.