Rice Lake IQ plus 710 Installation Manual page 28

SERIAL Menu
Parameter Choices
Level 3 Submenus
BAUD 9600
19200
300
600
1200
2400
4800
BITS 8NONE
7EVEN
Discontinued Product
7ODD
TERMIN CR/LF
CR
EOLDLY 0
number
HANDSHK OFF
ON
ADDRESS 0
address
BUS OFF
ON
STREAM OFF
ON
Level 3 Submenus
BAUD 9600
19200
300
600
1200
2400
4800
BITS 8NONE
7EVEN
7ODD
TERMIN CR/LF
CR
EOLDLY 0
number
HANDSHK OFF
ON
BUS OFF
ON
STREAM OFF
ON
24 IQ plus 710 Installation Manual
EDP Port
Baud rate. Selects the transmission speed for the EDP port.
Selects number of data bits and parity of data transmitted from the EDP port.
Termination character. Selects termination character for data sent from the EDP port.
End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
Specifies whether XON/XOFF flow control characters are used.
Specifies the decimal indicator address for RS-485 connections. RS-232 communications is
disabled if an address other than zero is specified for this parameter. RS-485 addresses must be
in the range 01–255.
Specifies whether the EDP port sends the data stream to a network bus. Specify ON only if the
Remote I/O or Profibus option is installed.
Specifies whether data is streamed from the EDP port.
Printer Port
Baud rate. Selects the transmission speed for the printer port.
Selects number of data bits and parity of data transmitted from the printer port.
Termination character. Selects termination character for data sent from the printer port.
End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
Specifies whether XON/XOFF flow control characters are used.
Specifies whether the printer port sends the data stream to a network bus. Specify ON only if the
Remote I/O or Profibus option is installed.
Specifies whether data is streamed from the printer port.
Table 3-5. Serial Menu Parameters (Continued)
Description