Replacing The Air Baffle - IBM x3550 M4 Type 7914 Installation And Service Manual

Replacing the air baffle

Use this information to replace the air baffle.
About this task
To install the air baffle, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables.
3. Remove the cover (see "Removing the cover" on page 36).
4. Align the air baffle pins with the baffle pin holes on both sides of the chassis;
then, lower the air baffle into the server. Press the air baffle down until it is
securely seated.
Note: Close the retaining clip on each end of the DIMM connector before
installing the air baffle for proper cooling.
Figure 109. Air baffle installation
5. Reinstall the cover (see "Replacing the cover" on page 209).
6. Slide the server into the rack.
7. Reconnect the power cords and any cables that you removed.
8. Turn on the peripheral devices and the server.
Chapter 6. Removing and replacing components
211