Rear View - IBM x3550 M4 Type 7914 Installation And Service Manual

The following illustration shows the LEDs and controls on the light path
diagnostics panel.
Figure 10. Light path diagnostics panel
v Remind button: This button places the system-error LED on the operator
v Reset button: Press this button to reset the server and run the power-on self-test

Rear view

The following illustration shows the connectors on the rear of the server.
Figure 11. Rear view connectors
20
IBM System x3550 M4 Type 7914: Installation and Service Guide
information panel into Remind mode. In Remind mode, the system-error LED
flashes once every 2 seconds until the problem is corrected, the server is
restarted, or a new problem occurs.
By placing the system-error LED indicator in Remind mode, you acknowledge
that you are aware of the last failure but will not take immediate action to
correct the problem.
(POST). You might have to use a pen or the end of a straightened paper clip to
press the button. The Reset button is in the lower-right corner of the light path
diagnostics panel.