Removing An Adapter - IBM x3550 M4 Type 7914 Installation And Service Manual

Figure 145. PCI riser-card bracket installation
10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.

Removing an adapter

Use this information to remove an adapter.
About this task
To remove an adapter, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords;
3. Disconnect any cables from the adapter. For PCI riser-card assembly 2, push the
248
IBM System x3550 M4 Type 7914: Installation and Service Guide
5. If you need to install an adapter (see "Replacing an adapter" on page 250).
6. Reconnect the cables for the adapter.
7. Replace the PCI riser card assembly (see "Replacing a PCI riser-card
assembly" on page 245).
8. Replace the cover (see "Replacing the cover" on page 209).
9. Slide the server into the rack.
"Installation guidelines" on page 33.
then, remove the cover (see "Removing the cover" on page 36).
latch to easily release the network cable, as shown in the following illustration.