Removing The Cover - IBM x3550 M4 Type 7914 Installation And Service Manual

Removing the cover

Use this information to remove the cover.
About this task
To remove the server cover, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect the power cords and
3. If the server has been installed in a rack, slide the server out from the rack
4. Pull up firmly on the blue latch on the top (in the center of the front of the
Figure 106. Cover removal
5. Lift the server cover off the server and set it aside.
208
IBM System x3550 M4 Type 7914: Installation and Service Guide
"Installation guidelines" on page 33.
all external cables, if necessary.
enclosure.
server) of the cover and slide the cover toward the rear of the server until the
cover has disengaged from the chassis.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.