IBM x3550 M4 Type 7914 Installation And Service Manual page 126

108
IBM System x3550 M4 Type 7914: Installation and Service Guide
– Devices and I/O Ports
Select this choice to view or change assignments for devices and
input/output (I/O) ports. You can configure the serial ports, configure remote
console redirection, enable or disable integrated Ethernet controllers, the
SAS/SATA controllers, SATA optical drive channels, PCI slots, and video
controller. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the
device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and
power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant. The default is Enable.
- Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy
boot order. The default is Disable.
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The
default is Enable.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to set the mode of operation after the power lost.
- Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on
IMM. The default is Enable.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address, specify
whether to use the static IP address or have DHCP assign the IMM2 IP
address, save the network changes, and reset the IMM.
- Reset IMM to Defaults