Replacing A Pci Riser-Card Assembly - IBM x3550 M4 Type 7914 Installation And Service Manual

Replacing a PCI riser-card assembly

Use this information to replace a PCI riser-card assembly.
About this task
Note: PCI riser-card brackets must be installed even if you do not install an
adapter.
To install a PCI riser-card assembly, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing the cover" on page 36).
4. Check whether there are rubber stoppers come with your PCI riser-card
assembly 2. If there are rubber stoppers come with your PCI riser-card
assembly 2, skip to next step.
a. There are two kinds of rubber stoppers. Attach the two rubber stoppers on
PCI riser-card assembly 2, along the edges of the pin holes, as shown in
the following illustration.
Figure 142. Rubber stoppers installation
b. Attach the bigger rubber stopper near the latch of PCI riser-card assembly
2.
c. Attach the smaller rubber stopper near the pin hole of PCI riser-card
assembly 2.
Note: You can purchase the miscellaneous parts kit (FRU part number
94Y7571) to acquire three sets of rubber stoppers. Keep additional rubber
stoppers for potential future use.
5. Install the adapter in the new PCI riser-card assembly (see "Replacing an
adapter" on page 250).
6. Set any jumpers or switches on the adapter as directed by the adapter
manufacturer.
7. Remove the PCI filler panel, if one is present, from the rear of the server.
8. Align the PCI riser-card assembly with the PCI riser connector on the system
board; then, press down firmly until the PCI riser-card assembly is seated
correctly in the connector on the system board.
Chapter 6. Removing and replacing components
245